From CAD designs and layouts to precision manufacturing of materials,
to complete installations, you can be assured of products
and systems that meet or exceed your specifications.
Exacting System Specifications
- The Beverage Line Conduit Systems to be installed
hereunder shall be 4", 6", 8" or 10"
as specified on the Food Service drawings, corrosion
resistant Aluminum conduit tubing, conforming to ASTM-B313
and ANSI-H26, and H35.1, as manufactured by Kelly BevWay
Systems Co., Chicago, IL, 877-753-0600.
- Bends shall be long sweep type, of the same grade
and coated in the same manner as the tubing specified
above. Minimum centerline radius of all bends shall
be 24" for 4"O.D., 30" for 6" O.D.,
32" for 8"O.D., and 32" for 10"
O.D. No segmented elbows or short radius plumbing elbows
shall be permitted.
- All joints shall be made with a liquidtite mechanical
bolted coupling system or liquidtite slip coupling system.
Edges of tubing and bends must be deburred and smoothed
prior to forming joints. Expansion sleeves with a moisture
barrier must be provided where the conduit crosses building
expansion joints, liquidtite integrity maintained.
- No spiral formed tubing or duct, or other unsmooth
interior tubing or conduit will be permitted. PVC shall
be used only for underground and other buried portions
of the systems, Schedule 40 type with Long Radius Sweep
Bends, 24” for 4” PVC, 30” for 6”
PVC and 48” for 8” PVC.
- Multi-Clamped Pull Sleeves, four (4) feet long minimum,
must be provided for continued access to beverage lines
in accessible locations approximately every 100 feet
or every three (3) bends, whichever occurs first. Where
junctions are required, Pull Boxes having adequate inside
dimensions for pulling and turning will be provided
in place of a Pull Sleeve.
- Conduit system terminations shall be stubbed-up 4"
above finished floor unless otherwise called out on
drawings. All floor penetrations shall be sealed with
a UL approved firestop assembly method.
- All terminations shall be finished with a rounded
slip fitting end-mouth having a smooth bell-shaped swaged
outer edge.
- Support hangers will be double rod type and spaced
on 10 foot centers. Support hangers will be provided
within 1 foot of each Pull Box.
|
